What is a trickle charger and how to charge a car battery?

Trickle charge is the amount of charging done for an indefinite period. It could be for a night, a week, hell even a month. Trickle charge is a type of charging which is left for wholesome charging. It brings the dead or flat battery back to life from zero to 100 percent.

What is the use of trickle charging?

Our motive behind trickle charging is the very fact to keep depleted batteries charged and in the non-use form. This type of typically bonded charging is regulated when the vehicle is needed for the long run in the future. Big sled machines, fire rescue vehicles, cop cars, and military support are such applications of trickle charge.

Is it safe to trickle charge?

Yes, it is safe to have a trickle charge. Most of the trickle chargers come with a regulator and monitor. This allows charging your battery at a similar rate, from start to finish. Also, trickle charging allows you to overcome the fear of overcharging or charging at a fast rate.

Battery Tender Plus 021-0128, Battery Tender 022-0185G-DL-WH, Foval Automatic Battery, OrionMotorTech Automatic, and Noco G7200 are some of the top-rated trickle chargers in 2020. Be sure to look out for medium and portable size models to allow them to fit in your trunk.

How does a trickle charger work?

Firstly, brush up your charging alligator clips with a rough cloth to make them dry. Now set the appropriate voltage and current rate as per your battery requirements. Check all the buttons and switches on the charging port to the source.

Additionally, remove your keys and turn off the ignition. Make sure to prevent any wet contact surface to your car (rainy or muddy puddle) and let it stand in a ventilated or dry space.

The charging process can produce excessive hydrogen gas. This could lead to an explosion or a blow-off. So if you want to keep the garage as your wife saw it, don’t do anything stupid.

Locate the negative terminal to a ground location

Contrary to the normal charging, trickle charging lacks the use of the negative terminal. So you have to connect it to a point where it is out of contact.

Experts suggest that connecting your negatives with a free from excessive dirt, grime, and oil metallic frame could do well.

Next, you have to connect the positive terminals. Connect the positive terminal of the source (red-colored wire) to the battery.

Similarly, connect the negative wire (black colored one) to the ground location that we discussed above. Keep in mind to check the connections before plugging into the power socket.

Finally, switch on the source and look up into the monitor. The screen will show that charging has been started. Most trickle battery chargers show higher point deflection on an amp meter.

The meter also shows a lower point to zero on fully charged. If the meter reads low, unplug the switch and check the connections (especially the ground location).

This would start charging your battery with a trickle battery charger. If now, the charging fails, remove all connections and take your battery to a specialist as it is likely to be defective. If not, let it charge until it is full.

Source: https://bestfordriver.com/chargers/best-trickle-charger/

Share on:

Leave a Comment